Bell Aliant

IMPORTANT – Before you begin setup:

1: To use this DNS method to configure UnblockAll on your device, you must verify your current IP address in the DNS Settings section of My Account. If you have not done this, changing your DNS settings will not activate UnblockAll on your device. If you have questions, please contact support.

2: Before you change your DNS settings to use UnblockAll, please write down or save a screenshot of your current settings and server/IP addresses. This is very important if you need to revert back to them at any time. We also recommend you save this page or print it in case you have a problem during setup and need to refer to these instructions.

 To enable Unblockall on Bell Aliant Speedstream:

Step 1: Open your router administration page. It is usually one of the following:

http://192.168.0.1

http://192.168.1.1

If none of these links work, please consult your manual.

Step 2: Click on the top right icon – Advanced Settings

Step 3: Select Home Network Settings > Advanced Settings

Step 4: Choose Configure Local Home Networking Modem IP Network, then select Custom Settings

Step 5: Fill in DNS servers with:

Primary DNS: 173.214.251.71

Secondary DNS:  192.133.141.178

Step 6: Make sure “Use WAN” is unchecked

Step 7: Click OK to save the settings

Step 8: Restart router

 Note: Once you have completed configuration and restarted your router, you also need to restart any device on your network that you want to use with MediaHint for the router changes to take effect.

Try 7-day for Free for Unblock All content

Get full access to the Unblock All products with your free trial. No payment details needed

Start Your Free Trial